11.6'' OGS Touch Screen Panel Printing and Photo etching Sensor Process SCT-OA1-004423H manufacturer from China SUNCENT TECH GROUP LIMITED

11.6'' OGS Touch Screen Panel Printing and Photo etching Sensor Process

Place of Origin:

Zhejiang, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

Model No.: SCT-OA1-004423H

11.6 Inch OGS Touch Screen Panel Printing and Photo etching Sensor Process

<span style="fo

11.6 Inch OGS Touch Screen Panel Printing and Photo etching Sensor Process

Quick Detail:

ITO Glass + ASF + FPC + Adhesive
Sensor Process: Printing + Photo etching
ITO Glass: 1.1 mm
ASF: 0.1 mm
Total Thickness: 1.33±0.1 mm
Surface Hardness: 6H

Specification:

Model No.	SCT-OA1-004423H
Size	11.6 inch
Active Area	260.13 x 148 mm
Structure	OGS
Sensor Glass	1.1 mm
Total Thickness	1.3±0.1 mm
FPC	Pitch=0.8 mm
Surface Hardness	6H
Connection	COF
IC Model	ELAN 3912
Transparent	≥87%
Operating temperature	-2070, ≤90%RH
Storage temperature	-3080, ≤90%RH

Assembly Precautions:

Do not exert extra force to touch panel.
Since touch panel is transparent and clear,make sure to wear fingerstall or glove before touching.Be careful of your hands and other parts from injury at handling by glass corners.
When handling,make sure to hold the touch panel borders not center parts to avoid dirt to touch panel. Do not lift touch panel by tail to avoid tail loosen.
When installing and assembling, do not lift tail with heavy force to avoid tail peeling off touch panel.
Do not stick or mount other parts on the tail, such as additional film or metal plate. As it will exert extra force to tail tip and cause tail loosen.
Please don't pull FPC with force from side to side, because the FPC tension will make FPC burst.
If there is air groove on touch panel, when design product structure, make sure no liquid and powder near the air groove.
In order to avoid heavy stress to touch panel surface, make sure to keep 0.2mm-0.5mm assembling gap between touch panel and case.

About Us

Main Structure:

GG structure
GG structure uses cover glass plus sensor glass solution, harder than PG structure, high transmittance and good effect for anti-scratch.

PG structure
PG structure uses one PET film plus sensor glass solution. Mature process technology greatly reduces the failure rate and cost. It has the same level weight with OGS structure.

OGS structure
OGS uses one glass solution, directly form ITO conducting film in the protective glass and use the sensor technology. It has the advantage of the simple structure, light, thin and good transmitting etc.

Main Material: